INDEX-4 P Period time of the display, components used to determine, 6-20 Power measurements, 2-1 Power meters, 5-1 Probe of the scope, components used to calibrate the, 6-26 R Radio-frequency (rf) signal generators, 5-10 Rejected—refer to attached tag label, 1-6 Repair procedures, 1-7 Resistance-capacitance-inductance (RCL) bridges, 1-21, 4-20 Resistance measurements, 1-20, 4-21 Resistance, meters used for measuring, 3-17 Resistance test, 3-29 S Safety shorting probe, 1-16 Scope triggering, components used to select,    6-25 Ship Configuration and Logistic Information System (SCLSIS), 1-3 Shorts, test for, 3-28 Shunts, 3-6 Signal Generators, 5-8 Special-application test equipment, 5-1 audio and video signal generators, 5-8 direct-measuring power meter, 5-2 frequency counters, 5-11 general description of the frequency counters, 5-12 indirect-measuring power meters, 5-4 integrated circuit (IC) testing device, 5-20 interpreting power measurements made by a wattmeter, 5-3 operation of the wattmeter, 5-3 power meters, 5-1 radio-frequency (rf) signal generators, 5-10 signal generators, 5-8 tracker 2000, 5-22 Special calibration label, 1-5 Spectrum analyzer, 6-37 Spectrum analyzer—Continued basic functional description, 6-38 converter section, 6-38 digital control section, 6-40 display section, 6-39 frequency control section, 6-39 front panel controls, indicators, and connectors, 6-40 IF section, 6-39 normal  indications upon power on, 6-44 power and cooling section, 6-40 use of the, 2-18 Stable display, components used to provide a, 6-22 Stroboscope, 2-10 T Tachometer, 2-8 Test equipment administration, 1-1 “no reject” policy, 1-7 calibrated—refer to report label, 1-4 calibration and repair, 1-3 calibration label, 1-3 calibration not required label, 1-6 calibration status, 1-3 calibration void if seal broken label, 1-6 electronic test equipment classification,    1-2 inactive—calibrate before use label, 1-6 Joint Electronics Type Designation System (JETDS), 1-2 Metrology Automated System for Uniform Recall and Reporting (MEASURE), 1-8 rejected—refer to attached tag label, 1-6 repair procedures, 1-7 responsibility for repair and maintenance of test equipment, 1-7 special calibration label, 1-5 stowage and handling of test equipment,   1-7 test equipment identification, 1-2 user calibration label, 1-5 Test equipment, using, 1-12 basic measurements, 1-18 capacitance, inductance, and resistance bridges, 1-21