2 1-8.   Under what circumstances should the USER CALIBRATION label be affixed to a piece of test equipment? 1.   When a certain calibration schedule is assigned 2.   When user calibration is required before, during, or after use 3.   When the equipment is out for calibration 4.   Each of the above 1-9.   Which of the following statements must appear on the CALIBRATION NOT REQUIRED label affixed to an instrument? 1.   By what authority the label was affixed 2.   The reason no calibration is required 3.   The date the label was affixed 4.   The METRL page number 1-10.   Which of the following labels is attached to an unusable instrument, and may have an additional tag attached? 1.   INACTIVE 2.   REJECTED 3.   CALIBRATED 4.   SPECIAL CALIBRATION 1-11.   A test instrument that has plug-in modules and/or easily accessible potentiometer or controls which affect the calibration of the instrument should have which of the following labels attached? 1.   CALIBRATED 2.   CALIBRATION NOT REQUIRED 3.   CALIBRATED—REFER TO REPORT 4.   CALIBRATION VOID IF SEAL BROKEN 1-12.   A replacement part needed by an IMA to repair a piece of test equipment should be ordered by the activity sending the inoperative equipment for repair and calibration. For which of the following reasons is this a good practice? 1.   IMAs are not allowed to order repair parts 2.   The ship has more repair funds than the IMA 3.   The ship is usually able to obtain the parts more quickly 4.   It is more likely the technician on the ship will obtain the correct part 1-13.   When maintenance personnel are not authorized to make repairs to a piece of test equipment, what items, if any, must be sent to the calibration repair facility with the equipment? 1.   The unit and its power cord 2.   All the accessories 3.   Standards used to calibrate 4.   None 1-14.   In what type of environment should test equipment be stowed? 1.   Dry 2.   Dark and damp 3.   High humidity and low temperature 4.   High temperature and high humidity 1-15.   In a stowage space aboard ship, what device(s) should be used to hold the test equipment in place? 1.   Set clasp springs 2.   Tie down cord 3.   Steel straps 4.   Stretch seat-belt-type straps