8
1-49. Ground planes and shielding are used to
prevent which of the following electrical
interactions?
1. Cross talk
2. External interference
3. The generation of rf within the
system
4. All of the above
1-50. Training requirements for miniature and
microminiature (2M) repair personnel
was established by which of the
following authorities?
1. Chief of Naval Education and
Training
2. Chief of Naval Technical Training
3. Chief of Naval Operations
4. Commander, Naval Sea Systems
Command
1-51. The standards of workmanship and
guidelines for specific repairs to
equipment are contained in which of the
following Navy publications?
1. Introduction to Microelectronics
2. NAVSHIPS Technical Manual
3. Electronics Installation and
Maintenance Books (EIMB)
4. Miniature/Microminiature (2M)
Electronic Repair Program
1-52. A technician is authorized to perform
2M repairs upon satisfactory completion
of which of the following types of
training?
1. A 2M training class
2. On-the-job training
3. NEETS, Module 14
4. Any electronics class "A" school
1-53. Repairs that are limited to discrete
components and single- and double-
sided boards are classified as what level
of repairs?
1. Intermediate
2. Organizational
3. Miniature component
4. Microminiature component
1-54. To ensure that a 2M technician
maintains the minimum standards of
workmanship, the Navy requires that the
technician meet which of the following
requirements?
1. Be licensed
2. Be certified
3. Be experienced
4. Be retrained
1-55. If a technician should fail to maintain
the required standards of workmanship,
the technician's certification is subject to
what action?
1. Cancellation
2. Recertification
3. Reduction to next lower level
4. Withholding pending requalification
1-56. The most extensive shop facilities and
highly skilled technicians are located at
what SM & R level of maintenance?
1. Depot
2. Operational
3. Intermediate
4. Organizational
