10
1-65. Which of the following types of test
equipment is classified as off-line
automatic test equipment?
1. Centralized Automatic Test System
(CATS)
2. Versatile Avionic Shop Test System
(VAST)
3. General Purpose Electronic Test
Equipment (GPETE)
4. Test Evaluation and Monitoring
System (TEAMS)
1-66. Fault diagnosis using GPETE should
only be attempted by which of the
following personnel?
1. Officers
2. Technician strikers
3. Experienced technicians
4. Basic Electricity and Electronics
school graduates
1-67. During fault isolation procedures, a
device or component should be
desoldered and removed from the circuit
only at which of the following times?
1. After defect verification
2. For out-of-circuit testing
3. During static resistance checks
4. At any time the technician desires
1-68. 2M repair stations are equipped
according to the types of repairs to be
accomplished. The use of microscopes
and precisions drill presses would be
required in which of the following types
of repair?
1. Miniature
2. Microminiature
3. Both 1 and 2 above
4. Emergency
1-69. In the selection of a soldering iron tip,
which of the following factors should be
considered?
1. The complexity of the pcb
2. The composition of the pcb
3. The area and mass being soldered
4. The type of component being
soldered
1-70. The handpiece that can be used for the
greatest variety of operations is the
1. solder extractor
2. rotary-drive tool
3. resistive tweezers
4. lapflow and thermal scraper
handtool
1-71. Regardless of location, 2M repair
stations require adequate work surface
area, lighting, power, and what other
minimum requirement?
1. Heat source
2. Ventilation
3. Illumination
4. Dust-free space
1-72. Solder used in electronics is an alloy
composed of which of the following
metals?
1. Tin and zinc
2. Tin and lead
3. Lead and zinc
4. Lead and copper
1-73. A roll of solder is marked 60/40. What
do these numbers indicate?
1. 60% tin, 40% lead
2. 60% tin, 40% copper
3. 60% lead, 40% tin
4. 60% lead, 40% copper
