• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 2B.Schematic Diagram

Neets Module 04-Introduction to Electrical Conductors, Wiring Techniques, and Schematic Reading
Page Navigation
  128    129    130    131    132  133
17 IN ANSWERING QUESTIONS 2-46 AND 2- 47, REFER TO FIGURE 2B. 2-46.   If the headlights operate normally in the bright position but do not light in the dim position, what would be the probable cause? 1.     The dimmer switch is defective 2.     The light switch is defective 3.     A fuse is open 4.     The ground to the headlights is open 2-47.   Which of the following faults could cause the left tail light to be inoperative while the other lights operate normally? 1.     The light switch is defective 2.     The bulb is defective 3.     A fuse is blown 4.     There is no voltage to point 2 2-48.   When you solder or hot-wire strip fluoroplastic insulated wire, which of the following safety precautions should be observed? 1.     Wear a safety mask at all times 2.     Wear protective gloves 3.     Maintain good ventilation to carry off the fumes 4.     Do not allow the resin to touch the insulation 2-49.   If a circuit has power restored to it, what meter may be used to test the circuit? 1.     An ohmmeter 2.     A wattmeter 3.     A megohmmeter 4.     A voltmeter 2-50.   If excess solder adheres to the tip of a soldering iron, how should you remove it? 1.     Flow flux over the tip 2.     Wipe it off on a clean cloth 3.     Dip the tip in water 4.     Shake it off






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.