DOUBLE LACE

Custom Search

Back
SINGLE LACE

Up
Neets Module 04-Introduction to Electrical Conductors, Wiring Techniques, and Schematic Reading

Next
Figure 2-44.—Terminating double lace.

2-40 Figure 2-42.—Lacing branches and breakouts. Double lace should be used on groups of conductors that are 1 inch or larger in total diameter. Either a single lace or a double lace may be used on groups of less than 1 inch. Q50. How is the single lace started? DOUBLE LACE Double lace is applied in a manner similar to single lace, except that it is started with a telephone hitch and is double throughout the length of the lacing (figure 2-43). Both double and single lace may be ended by forming a loop from a separate length of cord and using it to pull the end of the lacing back underneath a serving of approximately eight turns (figure 2-44). An alternate method of ending the lacing is illustrated in figure 2-45. This method can also be used for either single- or double-cord lacing. Another method is by using a marling hitch as a lock stitch (figure 2-46) to prevent slippage. This procedure will also prevent unraveling should a break occur to the lacing.